1 lb Mold - Block Weight - 2" Slot

A series of durable aluminum 2 piece molds for making contoured hip weights from 6 to 11 lbs. Finished weights are easily removed. 10 lb

2 lb Mold - Block Weight - 2" Slot

3 Lb Mold - Block Weight - 2" Slot

4 Lb Mold - Block Weight - 2" Slot

A blend of phosphoric acid and certain suspending agents, this acidic cleaner will expedite the removal of scale, oxides, concretions, and other stubborn contaminants from inside STEEL dive tanks. It's biodegradable and can be flushed down drain systems without harm. It has FDS, USDA,CDA, CDF approval and also meets many mil-spec requirements. The acid concentrate, when diluted to 5 - 10% strength for use,will speed the process so that only 1-3 hours will be required for completion. NOTE: Use...

O-ring sealed adapter used in the #43280 Valve Tester of #46080 Test Stand to convert the thread to the 1/2 - NGT pipe thread used on older steel tanks and many small gas cylinders. Allows 1/2 - NGT valves to be used / tested in our Valve Tester or Workstations and Flowbenchees.

An O-ring sealed adapter for the test stand used on our #43280 Valve Tester or #46080 Test Stand, it convers the large tank thread to a 7/8 - 14 hydraulic port thread which is used on DIN (Genesis - Type) hi-pressure cylinder valves. Also allows DIN valves to be used /tested in our Valve Tester or Workstations and Flowbenches.

Chips are small, hard, randomly-shaped abrasive particles which will loosen scale and rust from tank walls, thereby augmenting the action of solvent chemicals to remove/suspend internal contamination. This material can be used in steel or aluminum tanks and with various adjunct solvents EXCEPT TANK ACID which will attack the chips and produce excessive gassing. Aluminum oxide has been successfully used for tank tumbling for 40 years. Use 25-35 lbs. per tank.

A special, screwdriver-like tool for tightening/removing the recessed core valve within buoyancy compensator air supply hoses.

Blank and Custom Square VTI Stickers. Redesigned for a 10 year cycle and printed on a white label with black print. Quantity 1-999: stickers are $0.30 each. Quantity 1,000+: stickers are $0.25 each. For custom 81008 stickers (81008-xxxx)**, the MOQ is 500 stickers. Quantity 500-999: stickers are $0.60 each. Quantity 1,000+: stickers are $0.30 each. There is an initial single-color set up charge for custom VTI stickers. Additional charges will apply for multiple colors and/or changes to the...

Special, small stainless brushes for removing those stubborn deposits on the very bottom of dive tanks. Each brush screws onto a 3 - foot aluminum rod which fits into a 3/8" electric drill. Each unit comes with the brush, extender rod and a plastic guide sleeve to augment insertion through tank necks. Heavier, stiffer wire from bottom flash rust or other deposits in STEEL tanks. Not recommended for Aluminum models.